test video/pump

[Dawgmining]

I have nice camcorder on loan and after my house chores I started to figure it out. I spent most of the time learning about changing file types and upgrading device drivers. I should be able to post a new Liars gulch video wendsday.

But changing from a mod to a mov to wmv file killed the qaulity





http://www.youtube.com/user/dawgmining

[CalGoldDredger]

Sounds Great John, Love to see it!!!
Hey was that the Rogue or the Chetco on the youtube test video??? Nice!!!

John

[russau]

thanks for the video John. lots of good pointers for pumps!

[geno]

Thaqnks yu John...Lots of great info there. I have a keene p150 and was thinkng of usingit for my highbanker and make some attachable mods to make it a 3" combo dredge.
geno

[Dawgmining]

John That was the Klamath it was on the Camcorder when droped off. Looks like maybe by China point.

Geno 150 will do great on a highbanker. I would run the S hose in like a proline Just a better idea all around.
You can use the grey eltrical conduit to replace the footvalve peice if need be. the spacer for the impeller is 1.76 they can be cut out of metal conduit .I like to cut the a few long and work it done just untill the impeller is free of drag.

[pickaxe]

I was using a P150 to highbank two years ago. 5hp Briggs motor, 225 ft. of 1.5 layflat, 30+ foot of elevation gain on the hose running a 14in. box. I think the motor was running 1/4 throttle, had plenty of water.